Q.1 A house served by a 220V supply light, is protected by a 9-Ampere fuse. The maximum number of 60 W bulbs in parallel that can be
turned on is
(a) 11 (b) 33
(c) 22 (d) 44
Q.2 An n-channel JFET has IDSS = 1 µA & VP =-5V. The maximum transconductance is
(a) gm = 0.4 milli mho (b) gm = 0.04milli mho
(c) gm = 0.04 mho (d) gm = 0.4 millimilli mho
Q.3 The base to base resistance of a UJT is 6 K Ohm when the emitter current is zero. If RB1 = 3.6 K Ohm, the intrinsic stand off ratio
is
(a) n = 0.66 (b) n = 0.6
(c) n = 6.0 (d) n = 3.6
Q.4 A capacitor of 1µF initially charged to 10 V is connected across an ideal inductor of 0.1 mH. The maximum current in the circuit is
(a) 0.5 A (b) 1 A
(c) 1.5 A (d) 2 A
Q.5 Silicon has a preference in IC technology because
(a) it is an indirect semiconductor
(b) it is a covalent semiconductor
(c) it is an elemental semiconductor
(d) of the availability of nature oxide SiO
Q.6 Three equal resistance of magnitude 5 Ohm each are connected in delta. The resistance between any two pair of terminals of the delta
will be
(a) 5 Ohm (b) 5/3 Ohm
(c) 10/3 Ohm (d) 3/5 Ohm
Q.7 The R.M.S. value of a half wave rectified sinusoidal alternating current with peak value Im is
(a) Im/1 (b) mI / 2
(c) mI /2 (d) mI 3
Q.8 For a series resonant circuit, at the half power points,which of the following is true?
(a) Current is half of the current at resonance.
(b) Resistance is equal to the reactance.
(c) The impedance is half the impedance at the resonance.
(d) None of the above
Q.9 The lossless line of characterstics impedance 300 Ohm is terminated in a pure resistance of 200 Ohm. The value of the standing wave
ratio is
(a) 1.5 (b) 0.67
(c) 1.0 (d) 1.25
Q.10 The transient current in lossless L-C circuit when excited from an AC source is, sine wave
(a) Critically damped (b) Underdamped
(c) Overdamped (d) Undamped
Q.11 The values of L and C for a low pass filter with cut off frequency of 2.5 KHz and operating with a terminated load resistance of
450 Ohm are given by
(a) 57.3 mH; 0.283 µF (b) 28.66 µH; 0.14 µF
(c) 114.64 mH; 0.566 mF (d) 50.23 mH; 0.632 mF
Q.12 The driving point impedance with poles at ? = 0(zero) and ? = 8 (infinity) must have the
(a) s term in the denominator and an excess term in the numerator
(b) s term in the numerator and an excess term in the denominator
(c) s term in the numerator and equal number of terms in the
numerator and denominator
(d) s term in the denominator and equal number of terms in the
numerator and denominator
Q.13 A transmission line is terminated at its characterstic impedance. The reflection coefficent is
(a) 1 (b) -1
(c) 0 (d) 8
Q.14 In the circuit shown below, the current through the 3/11O resistance between terminals A & B is
(a) 4 Amps (b) 1 Amp
(c) 2 Amps (d) 5 Amps
Q.15 In a series RLC circuit operating below the resonant frequency the current
(a) I leads Vs (b) I lags Vs
(c) I is in Phase with Vs (d) None of these
Q.16 An antenna has maximum radiation intensity Umax = 10 Watt/Sr and average radiation intensity Uavg = 4.5 Watt/Sr. If the efficiency
of the antenna is given as ?r = 95%, the input power of the antenna is
(a) 2.222 Watt (b) 12.11 Watt
(c) 55.55 Watt (d) 59.52 Watt
Q.17 In an airport, a receiving, antenna has a maximum dimension of 3 metres and operates at 100 MHz. An aircraft approaching the
airport is 1/2 Km away from the antenna . The aircraft is in the region of the antenna.
(a) far-field (b) near-field
(c) close-field (d) Out of reach
Q.18 A lossless transmission line with characterstic impedance 500 Ohms is excited by a signal of voltage 10?0° volts at 1.2 MHz. If the
line is terminated by ZL at a distance 1 Km, the input impedance s of the line for ZL = 8 (infinity) and ZL = 0 (zero) in Ohm,
respectively are
(a) +j8, 0 (b) -j8, 0
(c) 0, – j8 (d) 0, +j8
Q.19 If the electric field of a plane wave is represented by E = 10 yˆ cos (109 t+30z) volt/m, assuming e is the dielectric constant,
the corresponding magnetic field H is
(a) – ˆy e 109/3 cos (109 t + 30z) Amp/m
(b) – ˆx e109/3 cos(109t + 30z) Amp/m
(c) – ˆz e 109/3 cos (109t + 30 z) Amp/m
(d) + ˆx e 109/3 cos (109t+30z) Amp/m
Q.20 A 50 Ohm lossless line connects a signal of 200 KHz to a load of 200 Ohm. If the load power in 100 mW, the value for voltage
minimum Vmin is
(a) ( 20)/4 (b) ( 10)/ 4
(c) ( 20)/ 2 (d) ( 10)/ 2
Q.21 Choose the correct statement
(a) Digital multimeters are built using current measuring elements, while analog multimeters are built using voltage measuring units
(b) Digital multimeters are built using voltage measuring units, while analog multimeters are built using current measuring units
(c) Both digital and analog multimeters are built using voltage measuring units
(d) Both digital and analog multimeters are built using current measuring units
Q.22 An analog voltmeter has a sensitivity of 10kO/volt. The galvanometer used in constructing the instrument will produce a full scale
deflection when the current passed through it is
(a) 10 mA (b) 20 mA
(c) 50 mA (d) 100 µA
Q.23 The input versus output characteristics of a digital-to-analog converter is given in the table below: The converter is exhibiting
(a) offset error (b) statistical error
(c) linearity error (d) hysteresis error
Q.24 An optical fiber cable laid underground has developed a discontinuity at a distance d from the source end. The fault can be located
using the instrument
(a) Optical spectrum Analyzer (OSA)
(b) Optical Time Domain Reflectometer (OTDR)
(c) Optical Power Meter (OPM)
(d) Laser Diffractometer (LD)
Q.25 Two sinusoidal signals of the same frequency are displayed on a dual-trace oscilloscope. One complete cycle of each signal covers 6
cm of the horizontal scale and the starting point of the horizontal scale and the starting point of the two signals are separated by 0.5
cm. The phase difference between the two signals in degrees is
(a) 30 (b) 45
(c) 60 (d) 90
Q.26 Transient signals can be observed using
(a) storage oscillocope (b) sampling oscilloscope
(c) wave analyzer (d) spectrum analayzer
Related posts:
- BSNL JTO 2009 Sample Model Question Paper
- BSNL JTO (Junior Telecom Officers) Previous Year Question Paper with Answers
- SAIL Latest Placement Paper (Technical, Reasoning and Apptitude)
- ISO Sample Paper for CS/IT Scientist Engineers Recruitment
- Andhra Bank Sample Model Paper 2008 batch – General Awareness
Tags: BSNL, BSNL JTO, sample paper
